Since SW08, a regression in table positioning has been found. The stationary corner is not saved to the template like it was in 2007 and before.
This results in possibly having to change the table orientation if your table isn’t in one of the 4 corners.
IE. I have a revision table that is inserted near bottom middle of our title block. I cannot save the rev block table orientation (top left) to the template. It always gets inserted into the drawing with bottom right orientation.
If this affects you, submit a service request through your VAR with SPR 464547 attached to it.
If you're new here, you may want to subscribe to my RSS feed Or install the SolidWorks addin to put this help where you need it when you need it, in the SolidWorks environment! You can get the addin here. Thank you for visiting!
