Speedpak and assemblies. I have an assembly with a part patterned 36 times in the assembly. Now when I select the outside face of one of the parts in the pattern for the speedpak it then patterns the face in the speedpak config thus making speedpak no so speedpak-ish anyone else encounter this and know if there is a work around?
CBL are discussing.
CBL 8:05 pm on September 21, 2011 Permalink
I haven’t tried, but could you create a separate surface (in place of the parts face) in the assy and use that in the Speedpack?
Ben 10:57 am on September 22, 2011 Permalink
Ya thats where I am heading. I was hoping to not have some extra parts cluttering up the FM though
Brian 1:54 pm on September 28, 2011 Permalink
I haven’t ever tried with a patterned component, but I just did and see the same behavior. Not sure about a work-around. Did the surfaces work for you?