Is this saved view one of your configurations? If it is, then drag another similar view and go to it’s properties and change it to the configuration of the sectioned view.
I don’t think one can drag a saved section view into a drawing from view palette. That is meant for view in part/assembly mode only. You need to make a configuration with the cut or do the section the drawing.
admin 4:07 pm on March 3, 2009 Permalink
I cannot replicate this. Do you have configurations in this part or assembly and is it going to the wrong config? Just a stab in the dark….
CBL 8:15 pm on March 3, 2009 Permalink
If you mean a saved section view created from the heads-up menu, it doesn’t work for me either.
Alan 6:53 am on March 4, 2009 Permalink
Is this saved view one of your configurations? If it is, then drag another similar view and go to it’s properties and change it to the configuration of the sectioned view.
gupta9665 3:22 am on June 12, 2009 Permalink
I don’t think one can drag a saved section view into a drawing from view palette. That is meant for view in part/assembly mode only. You need to make a configuration with the cut or do the section the drawing.