I just installed SW2010. I have been using SW2006 up until now. When I try to open my 2006 files, I am told that the files are read only. How do I enable write access for these files. I want to save them as 2010 files.
gupta9665 is discussing. Toggle Comments
Do you have rights to modify these files. If yes then right click on then and select properties. Then in the pop dialog box uncheck read only. And finally click OK to apply the changes. You can select multiple files at same time and do this.
You must be logged in to post a comment.
← So I have finally launched my new site. …
what are piercing points →
Proudly powered by WordPress. Theme: P2 by Automattic.