I am making an assembly with a hydraulic…
I am making an assembly with a hydraulic cylinder. I would like the shaft of the cylinder to freely move in and out but be constrained by the start and stop of the stroke length. How do I do this mate?
-
dave spencer
Reply
You must be logged in to post a comment.
CBL 12:43 pm on February 1, 2010 Permalink
Use the Limit Mate.
http://help.solidworks.com/2010/English/solidworks/sldworks/assem_1/limit_mates.htm
dave spencer 1:02 pm on February 1, 2010 Permalink
Thanks so much! I was staring right at it but did not realize it.