Hello, Please I have a little issue to S…
Hello,
Please I have a little issue to Sheet Metal:
-Who control the length in sheet metal part when you edit a wall with Edge-Flange? the length setting in tab Flange Length OR the dimensionset up in sketcher with Edit Flange Profile!?Thank you.
Regards,
Sorin,
bhughesnles 2:15 pm on February 8, 2010 Permalink
Typically, whichever you set last. If your sketch fully defines the flange and you don’t make any changes to the flange length, then the sketch. If you sketch is not a simple rectangle, your sketch should also be the defining force in such case. However, when you sketch is a simple rectangle or retains portions of the originally generated rectangle it is possible to override the sketch driven dimension via the flange length box. Best practice, pick one place and stick with it.
salbu 3:52 pm on February 10, 2010 Permalink
Thank you.I appreciate.
Sorin,