Username
Password
Remember Me
This is new to me. Any thoughts on what is going on or why?!?!?! I am at a loss for words
w.wolf, CBL, and jjimenez are discussing. Toggle Comments
I have seen it before in SW2010 SP2 (I think). It was a problem with some Office dll that were overwritten. Try to reinstall again Office.
This has been reported several (many) times on the SW forums https://forum.solidworks.com/message/199857#199857
Same for Excel 2010 https://forum.solidworks.com/message/237506#237506
Unfortunately, I don’t believe any “one size fits all” solution was ever posted, but various bug reports exist in the SW KB.
If you think that’s funny, take a look at this. https://forum.solidworks.com/thread/26168?start=0&tstart=0
You must be logged in to post a comment.
← Hi 1 Can I split the dxf or…
Hello there Ben as promised I have a… →
This is new to me. Any thoughts on what is going on or why?!?!?! I am at a loss for words
w.wolf, 
CBL, and 
jjimenez 11:44 pm on October 20, 2011 Permalink
I have seen it before in SW2010 SP2 (I think). It was a problem with some Office dll that were overwritten. Try to reinstall again Office.
CBL 6:42 am on October 21, 2011 Permalink
This has been reported several (many) times on the SW forums
https://forum.solidworks.com/message/199857#199857
Same for Excel 2010
https://forum.solidworks.com/message/237506#237506
Unfortunately, I don’t believe any “one size fits all” solution was ever posted, but various bug reports exist in the SW KB.
w.wolf 6:02 am on October 23, 2011 Permalink
If you think that’s funny, take a look at this.
https://forum.solidworks.com/thread/26168?start=0&tstart=0